Installation
Install Beskar™ Ingot Drive
- Before installing Beskar™ Ingot Drive, power down your computer and unplug any cables attached to it.
- Open the case or cabinet.
- If an existing SSD drive is installed in the M.2 PCIe slot you intend to use for Beskar™ Ingot Drive, you'll need to remove it.
- Power on your computer.
- Access the BIOS setup while the computer is booting. Ensure that a PCIe device is set in the BIOS boot sequence or boot priority list.
- Power down the computer and locate the M.2 PCIe slot on your motherboard.
![](/content/dam/seagate/migrated-assets/www-content/manuals/firecuda-520-cyberpunk/_shared/images/firecuda-520-ssd-slot-03.jpg)
Note—Some motherboards have a pad installed in the M.2_PAD space by default. This pad can be removed to ensure a better fit for Beskar™ Ingot Drive.
![](/content/dam/seagate/migrated-assets/www-content/manuals/firecuda-520-cyberpunk/_shared/images/firecuda-520-ssd-m.2_pad.jpg)
- Check to make sure that the notch on Beskar™ Ingot Drive is correctly aligned with the divider in the slot. Gently push the SSD into the slot until it's firmly seated.
![](/content/dam/seagate/migrated-assets/www-content/manuals/beskar-se-firecuda/_shared/images/firecuda-530-install-A-03.jpg)
- Hold down Beskar™ Ingot Drive while you fasten the mounting screw. Make sure the SSD is secured in place.
![](/content/dam/seagate/migrated-assets/www-content/manuals/beskar-se-firecuda/_shared/images/firecuda-530-install-B-02.jpg)
- Close the case or cabinet and reassemble your computer.
- Power on your computer.
- Install the computer operating system on Beskar™ Ingot Drive if you want to use it as the primary drive.